Horner-apg SmartStack I/O HE-RTD100* Instrukcja Użytkownika Pobierz pdf (Strona 2)

PAGE 2 10 NOV 2006 MAN0236-09

RTD000/100

This Data Sheet is published individually & also as a part of the SmartStack Supplement (SUP0246-05).

Information is subject to change without notice. SmartStack is a trademark of Horner APG, LLC.

2 WIRING

Signal

RTD100 RTD000

1E RTD1 Excitation RTD1 Excitation

1S RTD1 Sense RTD1 Sense

1C RTD1 Common RTD1 Common

Shield Shield

2E RTD2 Excitation RTD2 Excitation

2S RTD2 Sense RTD2 Sense

2C RTD2 Common RTD2 Common

Shield Shield

3E RTD3 Excitation

3S RTD3 Sense

3C RTD3 Common

Shield

4E RTD4 Excitation

4S RTD4 Sense

4C RTD4 Common

Shield

3 CONFIGURATION

Note: The status of the I/O can be monitored in Cscape Software.

Preliminary configuration procedures that apply to SmartStack™ Modules are contained in the hardware

manual of the controller you are using. Refer to the Additional References section in this data sheet for

a listing of hardware manuals.

Module Setup Tab

a) Sensor Type for each channel may be selected independently.

b) Temperature format may be set for various C° or F° ranges.

c) Filter Constant sets the level of digital filtering according to the chart below.

d) Reject Rates sets the frequency level for noise rejection at 50 or 60HZ.

I/O Map Tab

The I/O Map describes which I/O registers are assigned to a specific SmartStack™ Module and where the

module is located in the point map. The I/O Map is determined by the model number and location within

the SmartStack™. The I/O Map is not

edited by the user.

OCS Bottom View – Shows

Corresponding I/O Pin

001RTD001

1 2 3 4 5 6

Brak uwag

Horner-apg SmartStack I/O HE-RTD100* Instrukcja Użytkownika Strona 2